DYNAMIC DIAMOND TOOLING Beast - 6 Safet Egarding Maintenance; 7 Safet Egarding Transport

2.5 Definition of “SAFETY POWER OFF” position
The machine is secured in a safe condition and cannot present a hazard.
How to set the machine in the SAFETY POWER OFF position:
1 Switch off the machine
2 ait for all grinding drives to come to a complete stop
3 Disconnect the main power
4 Secure against unintended restart
Alwas disconnect the main power at the machine end to be able to prevent other
persons from accidentall reconnecting the main power while working on the
machine
2.6 Safety regarding maintenance
Set the machine to the SAFT  FF position before beginning an
workmaintenance on the machine
hen the machine has been operated the tooling and tooling plate along with other
parts in the drum ma be hot Take etra care to prevent burn injuries
The machine must not be connected to an power source while cleaning
2.7 Safety regarding transport
It is recommended to transport the machine with diamond tooling installed This will
prevent the bottom plate from being damaged during transport
Page 7
Dynamic Diamond Tooling
DDG 1220 User Manual