Installation, Operation and Service Manual LKAT
2
Portable
© 2018 DynAmp, LLC Page 17
047312 A
Photocopy the appropriate LKAT2 Diagnostic Measurements Forms. Form 1 is for
diagnostic measurements at zero bus current (with the Measuring Head on or off the bus).
Form 2 is for diagnostic measurements with the Measuring Head installed on the bus with
the bus energized. Follow the directions to measure and record necessary information.
NOTE:
• These forms are intended to help keep accurate records of LKAT
2
functional tests.
• This information may prove valuable in the event of a malfunction.
• These measurements do not constitute system calibration.
• Space is provided for the recording of three sets of readings.
• Voltages may vary slightly with temperature extremes.
• System performance will typically remain within nominal specifications when measured
levels fall within the acceptable limits shown on the forms.
• Levels must be measured and recorded under test conditions shown on the forms.
Always complete these forms in full before contacting the factory.
To Next Page
Loading...
