To Next Page

To Previous Page

CC 102/C/122/C/132/142/C O102EN3

Vibration is engaged and disengaged with the

changeover switch (20) on the forward/reverse lever.

Always switch off vibration before the roller comes to a

complete standstill.

Vibration should not be allowed when the roller

is stationary; this may damage the surface

and the machine.

Manual/Automatic vibration

Fig. 21

5. Vibration switch

Fig. 23 Instrument panel

14. Vibration front/rear drum

Fig. 22 Forward/reverse lever

20. Vibration ON/OFF

Vibration on one drum (Optional)

OPERATION/VIBRATION

Select manual or automatic switching ON/OFF with

switch (5).

In manual mode, the operator must activate vibration

via the switch (20) on the forward/reverse lever.

In automatic mode, the vibration is activated when the

pre-set speed is reached.

Even switching off is automatic when the lowest speed

is reached.

Manual vibration—Switching on

The selector switch (14) is used to choose vibration on

the rear drum only or on two drums, ON/OFF.

In vibration ON mode, the operator must activate vibra-

tion via the switch (20) on the forward/reverse lever.

In left position, vibration is applied to both drums.

In right position, vibration is activated on the rear drum.

Dynapac CC122C User Manual

Other manuals for Dynapac CC122C