EasyManua.ls Logo

Dynapac CC800 - Hydraulic Reservoir - Check;Venting

Dynapac CC800
116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance - 1000h
4812160801_D.pdf 2018-12-17
Hydraulic reservoir - Check/venting
Figure. Engine compartment, right side
1. Hydraulic fluid tank cap
1
Unscrew and make sure that the reservoir cap is not
blocked. Air must have unobstructed passage through
the cap in both directions.
If blocked in either direction, clean with a little diesel oil
and blow with compressed air until unblocked or
replace the cap with a new one.
Wear eye protectors and gloves when working
with compressed air.
Wear eye protectors and gloves when working
with compressed air.
Fig. Engine compartment, right side
1. Sight glass
1
Check the hydraulic oil level in the sight glass (1) and
top off where necessary. See under the heading
‘Every 10 hours of operation’.
94

Table of Contents

Related product manuals