No heat or heat too low
Pump will not prime
Jets won't come on
Probable Cause #1
Action
Dirty Filter
Clean Filter / Pull Filter and try running without filter
Probable Cause #2
Action
Probable Cause #3
Action
Breaker at house off.
Reset breaker at house. Breaker can appear to
be on and one pole can be off. Turn breaker OFF
then ON twice.
Pump not primed.
Refer to the section of this manual on pump
priming
Probable Cause #4
Action
Improper line voltage.
Have a Licensed Electrician check the line voltage.
Probable Cause #1
Action
No water in pump
Make sure water level in spa is correct. Adjust bleed
screw located on spa wall next to skimmer area.
Probable Cause #1
Action
Pump not primed.
Refer to the section of this manual on pump priming.
Probable Cause #2
Action
Gates Valves closed.
Check to see if gate valves are in the correct position.
Check to see that pump is purged in.
Probable Cause #2
Action
Closed gate valves or blocked lines.
Open all gate valves. Check suction for blockage.
Probable Cause #4
Action
Air lock
Adjust bleed screw located on spa wall next to
skimmer area.
Probable Cause #3
Action
Pump surges, jets lose power, then comes back,
then loses power again etc.
Check union on front or nose of pump to ensure
tightness. Check drain plugs to ensure tightness.
Trouble Shooting Guide
29
To Next Page
Loading...
Need help?
General