3000 & 4000 Systems
Depending on the Dynasty Spa model you purchased, you'll have different options
available to you with Dynasty's digital controls. The operations of your hot tub
can be enjoyed at the touch of a button. This section is designed to walk you
through the details of the operation of the Dynasty 3000, 4000 & 5000 controls.
Top Side Control Instructions
12
When water temperature is 1˚F (0.5˚C) lower
than the Set Point, the heater will automatically
turn on until water temperature reaches Set
Point plus 1˚F (0.5˚C).
The "Heater" indicator lights up when
the heater is on. It flashes when there
is a request for more heat but the heater
has not yet started.
N.B.: If your system is configured in Low Current
Mode, the heater will not start if a pump is running
at high speed.
Press Pump 1 to turn Pump 1 on at low speed.
Press a second time to turn pump to high speed.
A third time turns pump off. A built-in timer au-
tomatically turns pump off after 20 minutes.
The "Pump 1" indicator lights up
when Pump 1 is on.
Press
Pump 2
to turn Pump 2 on. Press a second
time turns Pump 2 off. A built-in timer automati-
cally turns Pump 2 off after 20 minutes, unless it
has been manually deactivated.
The "Pump 2" indicator lights up
when Pump 2 is on.
Press Light to turn light on. Pressing a second
time turns light off. A built-in timer automatically
turns light off after 2 hours, unless it has been
manually deactivated.
The "Light" indicator is displayed
when light is on.
Fiber Box Option: If spa has an optional fiber
box, press Light key to turn fiber box (motor
and light) on. Pressing a second time turns fiber
box off but leaves light on. A third time turns
both motor and light off. A built-in timer turns
fiber box off after 2 hours, unless it has been
manually deactivated. The "Light" icon is dis-
played when fiber box light is on. It flashes
when fiber box motor and light are on at the
same time.
Use Up or Down arrow key to regulate water
temperature. The temperature setting will be
displayed for 5 seconds to confirm your new
selection.
The "Set Point" indicator displays the
desired temperature, NOT the current
water temperature!
Water temperature can be adjusted by 1˚ in-
crements from 59 to 104˚F (15 to 40˚C).
Press Econo key to switch from Normal mode
to Economy mode. In Economy mode, system
maintains temperature at the desired Set Point
during filter cycles only. Set Point is 20˚F (11˚C)
below the Normal mode Set Point for the rest
of the time. In Economy mode, the display will
toggle between the current water temperature
and the "Econ" message.
Starting Pump 1:
Starting Pump 2:
Turning the light on:
Setting water temperature:
Automatic water heater start:
Economy mode:
To Next Page
Loading...
Need help?
General