Dynatronics DYNATRON SmarTRAC - Attachment and Mounting

INSTALLATION
SMARTRAC | OPERATOR’S MANUAL REV. 0 | 4/06/2018 8
Attachment Carabiner Hook
Mounting on the Traction Frame
e SmarTRAC may be mounted on dierent traction tables by way of a traction frame/arm. Moreover, the device may be
mounted on a mobile traction frame for cervical traction. For mounting instructions, please refer to the manufacturers’
documentation included with the traction frame/arm.
CAUTION
e cord must be attached to the carabiner hook by means of a knot capable of withstanding considerable traction,
without coming undone. A suitable knot is shown in the gure below.
CAUTION
Do not place the device in a location where the power cord could be tripped over or pulled out during treatment.
Do not attempt to use the device if it is not properly grounded. Make certain that the device is electrically grounded
by connecting it only to a grounded electrical service receptacle that conforms to the applicable national and local
electrical codes regarding medical environments.