Dynatronics Dynatron T3 - Maintenance and Service; General Maintenance

MAINTENANCE AND SERVICE
DYNATRON® T3™ HI-LO TREATMENT TABLE & T4™ TRACTION TABLE | OPERATOR’S MANUAL REV. 10 | 4/4/2018 12
Maintenance
and Service
e table described in this manual oers some user-serviceable parts. is section provides suggestions for periodic
maintenance inspections as well as instructions for specic service or repair that may be performed by the user. For assistance
with any service-related matter or to obtain needed replacement parts, contact Dynatronics’ Customer Service department at
1-800-874-6251. NOTE: Only technically qualied personnel should attempt to service or repair this equipment.
GENERAL MAINTENANCE
If the bed is located in an area where it is subject to extreme amounts of moisture, humidity or dust, the pivot joints and
sliding surfaces should be cleaned and lubricated.
WARNINGS
An electric shock hazard may exist when electrical covers have been removed.
In addition, the mechanical action of the table may subject the repair person to signicant shearing and crushing
forces. erefore, repair must be performed only by qualied personnel who should proceed with care and use
proper servicing techniques. Servicing by unqualied personnel may void the warranty.