Dynatronics Dynatron T3 - Installation and Features; Unpacking; Setup

INSTALLATION AND FEATURES
DYNATRON® T3™ HI-LO TREATMENT TABLE & T4™ TRACTION TABLE | OPERATOR’S MANUAL REV. 10 | 4/4/2018 3
Installation
and Features
Unpacking
Upon receiving the table, immediately unpack it and verify that all parts and accessories are included. Check for possible
damage, obvious or concealed. In case of damage, immediately notify the freight carrier and take any steps necessary to le a
claim for the damage sustained. If possible, reuse the shipping carton if the table must be shipped for any reason. e carton
is specially designed to protect the table from shipping damage. Improper packaging of the unit during transport can result
in damage and invalidate the warranty.
Complete the warranty registration form located at the back of this manual and return it to Dynatronics within 30 days
of purchase. is is essential to insure you are not billed for services that are covered by the warranty policy. Warranty
registration should include all applicable serial numbers.
Setup
• Aer unpacking, set the table in the desired location. No assembly is required as the table is fully assembled and all
motors are pre-adjusted at the factory.
• Provide ample clearance around and above the table.
• Securely lock all four casters for stability. Install the traction arm for the T4 table (see instructions on the following
page). Inspect all cables and power cord for damage;
• Immediately report any damage found to Dynatronics’ Customer Service (800) 874-6251.