26 Dynaudio
Xeo Link
The Xeo Link receives wireless signals from a Xeo Hub or Xeo Extender and outputs analog and
digital signals from its connections. As a result, you can also connect active subwoofers, active
loudspeakers, or other components to the Xeo system.
Xeo Link can also be connected with a 1st generation Xeo transmitter. This lets you operate both Xeo
systems together.
Connections and control elements
Front
LED Operational state
LED illuminated in blue: The Link receives an audio signal and plays it back.
LED is ashing in blue: There is a connection, but no audio signal is transmitted.
LED is ashing in red: There is no connection to a Hub or Extender.
LED illuminated in red: Xeo Link is in standby mode.
Rear
Coax Out Output for electrical digital cable
Connect devices here that have an electrical digital input (coax).
Optical Out Output for optical digital cable
Connect devices here that have an optical digital input (Toslink).
Line out Output for cable with RCA plug
Connect devices here that have an input for the RCA plug.
Zone Audio zones
Select the desired audio zone here.
Power Connection for power supply unit
Connect the delivered Xeo power supply unit here.
Do not use a different power supply unit!
To Next Page
Loading...
General