Dynex DX-E102 User Manual

USER GUIDE
Desktop 10/100Mb Network Card
DX-E102
DX-E102-ENG.fm Page 1 Tuesday, October 20, 2009 7:43 PM

Dynex DX-E102 Specifications

General

Interface	Ethernet
Data Transfer Rate	10/100 Mbps
Network Standard	IEEE 802.3, IEEE 802.3u
Connector Type	RJ-45
Operating System Compatibility	Windows 98SE/ME/2000/XP
Device Type	Network adapter
Form Factor	Plug-in card
Bus Type	PCI

Summary

Introduction

Product Features

Safety Precautions

Package Contents

Installing the Adapter

Install Adapter Driver

Step-by-step guide for installing the necessary driver for the network card on Windows systems.

Using Wake On LAN

Troubleshooting Network Issues

Verify Adapter Installation

Procedure to confirm the correct installation of the network adapter in the system.

Check Cable Connections

Steps to ensure network cables are properly connected and free from interference.

Network Indicators and Testing

Pinging for Connectivity

How to use the PING command to test network communication and troubleshoot.

Technical Specifications

Legal Information

One-Year Limited Warranty

Warranty Coverage and Duration

Details on the length and scope of the product's warranty coverage.

Obtaining Warranty Service

Procedures for getting support and service under the warranty.

Warranty Validity and Exclusions

Information on where the warranty is valid and what it does not cover.

Warranty Exclusions