External Flip/Flop
If you have an external flip/flop switch connected (typically to your control stick or yoke),
pressing it flip/flops the active and standby frequencies just like pressing the dual concentric
knob does. See the SkyView / SkyView SE System Installation Guide for details on connecting an
external flip/flop switch.
Dual COM Radios
If you have more than one COM radio that is capable of communicating with SkyView SE, only
the primary COM radio’s status information will be displayed in the Top Bar. Additionally, only
the primary radio will receive airports or frequencies from SkyView SE when SkyView SE’s TUNE
or APT>COM buttons are used.
However, if your second COM radio is a Dynon SV-COM-C25/X25/X83, all of its control-panel
based features work just like the primary radio’s. In other words, you can still use the APT
button to load airports, the TWR/GND/ATIS/ATC buttons to tune frequencies, and
airport/station types are reverse-looked up when you manually tune the second radio.
To Next Page
Loading...
