Dynon Avionics SkyView SE - Page 86

Messages and Alerts
9-10 SkyView SE Pilot’s User Guide - Revision B
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Traffic Not Available”
None
n/a
Traffic is not available from a
previously available source
“Autopilot”
None
n/a
The roll or pitch autopilot axis has
been engaged
“Autopilot Mode”
None
n/a
The autopilot roll mode has
changed since it was engaged.
This includes sequencing onto an
armed mode (such as an ALT Hold
> VNAV sequence)
“Autopilot Disconnect”
None
n/a
The roll or pitch autopilot axis has
disconnected
“Trim Up”
None
n/a
The autopilot requires nose up
trim to maintain control of the
aircraft, and has been
annunciating this visually on the
display for at least 30 seconds.
This alert is played a maximum of
once every 30 seconds.
“Trim Down”
None
n/a
The autopilot requires nose down
trim to maintain control of the
aircraft, and has been
annunciating this visually on the
display for at least 30 seconds.
This alert is played a maximum of
once every 30 seconds.
“Autopilot Airspeed
High/Low”
None
n/a
The autopilot airspeed limits are
exceeded.
“Approaching Altitude” /
“Leaving Altitude”
None
n/a
Altitude alerter notification that
the aircraft is approaching or
leaving the bugged altitude
“Overspeed”
None
n/a
Indicated airspeed is exceeding
Vne
“Flaps Overspeed”
None
n/a
Indicated airspeed is exceeding
Vfe (and flaps are at least partially
deployed)
“Approaching Waypoint”
None
n/a
The aircraft is within 30 seconds
of an upcoming SkyView SE flight
plan waypoint (except the final
waypoint)