Carefully place the post-filter cover into the 2
locating points at the front of the machine and
then firmly clip the rear onto the LMC assembly.
Refit the pre-filter assembly into the top of the UMC.
Clip the pre-filter cover into the hinge points on the
rear of the UMC. Clip the pre-filter cover catch
over the retainer on the front of the UMC.
Refit the post filter as shown, ensuring that the
filter scrim is positioned with the 'teeth' down
(pad filter only).
Place the end of the hose assembly into the cyclone
inlet. Clip the hose retainer onto the front of the
product. Clip the cyclone and bin assembly onto
the machine.
Fitting notes
37
39
36
38
12
service manual
To Next Page
Loading...
