Fit the motor mount onto the motor plate. Align the
motor plate and mount onto the motor as shown.
Refit the wiring harness into the bucket if previously
removed. Ensure the grommet is adequately sealed.
Refit the fancase seal onto the base of the motor.
Align the motor bucket top with the motor bucket so
the arrow points towards the wiring harness grommet.
Firmly clip the motor bucket top onto the motor
bucket. Ensure the detail on the fancase seal
protrudes fully through the motor bucket top.
Connect the motor wires to the wiring harness.
Lower the motor into the motor bucket. Ensure the
motor mount locates into the detail in the end of the
motor bucket.
Fitting notes
23
24
26
27
25
Main body - assemble
9
service manual
To Next Page
Loading...
