Service manual
Product overview Technical info.
Fitting notes
Parts recognition
General notes
Motor and yoke assembly replacement - removal
Motor and yoke assembly replacement - fitting
Stabiliser and pedal replacement - removal
Stabiliser and pedal replacement - fitting
Valve wheel replacement
Valve hose replacement - removal
Valve hose replacement - fitting
Valve hatch replacement - removal
Valve hatch replacement - fitting
Switch and powercord - removal
Switch and powercord - fitting
Duct assembly replacement - dismantle
Duct assembly replacement - fitting
Sub assemblies - hose and wand assemblies
Sub assemblies - cyclone assembly
Sub assemblies - bin assembly
Sub assemblies - cleaner head assembly
Electrical safety testing
Electrical circuit
Electrical fault diagnosis
Main body
Motor assembly
Cyclone and bin assemblies
Cleaner head assembly
Wand and hose assemblies
Contents
This manual is written specifically for Dyson trained engineers and covers the full DC25
range. The service instructions assume the engineer has the approved tools and test
equipment with them.
Features 01
63
64
65
66
67
05
05
18
28
30
33
34
36
37
39
40
43
48
51
54
55
57
59
02
03
04
Page