Changing your HEPA and carbon filters
Before changing your filter, switch off and unplug your Dyson purifier fan
heater.
The remaining filter life is displayed on the screen and will indicate when your
non-washable filters need replacing. Press the Information button on your
remote or check on the Dyson Link app.
You’ll need to reset the filter life on your machine.
Dyson Purifier Hot+Cool
Supplied with separate HEPA and carbon filters.
To change your HEPA filter, push down on the buttons either side
of your machine to release the filter covers. Push down on the tabs
to remove the HEPA filter.
Push the replacement filter into the outer cover and make sure the
tabs click into place.
To change the carbon filter from your machine, remove the filter
from the base of your machine and insert the replacement filter.
Put the outer covers into position on your machine and push firmly
until they both click securely into position.
Plug in and switch your machine, and reset your filter life.
Resetting your HEPA and carbon filter life
It’s important to reset your filter life after you have replaced your filter.
Resetting your HEPA filter life
Press and hold the Night mode button on your remote control.
The display on your machine will countdown from five, the filter life will
be reset and your machine is ready to use.
Resetting your carbon filter life
Press and hold the Oscillation button on your remote control.
The display on your machine will countdown from five, the filter life will be
reset and your machine is ready to use.
5
sec
5
sec
To Next Page
Loading...
Need help?
General
