29E-flite F-86 Sabre 15 DF ARF Assembly Manual
5. When installing a remote receiver, attach it as
shown in the fuselage using hook and loop tape.
Intake Tube Installation
Required Parts
Assembled airframe
Intake tube Hook and loop strap
1. Remove the cover from the bottom of the
fuselage and set it aside in a safe location.
2. Prepare the hook and loop strap by attaching
the pieces together using a 2-inch (52mm)
overlap as shown.
3. Locate the intake tube. The circular end will fit to
the rear of the fuselage. The front is egg-shaped to
match the intake of the fuselage and the flatter side
will face to the bottom of the fuselage.
4. Place the hook and loop tape on the intake tube
at this time. This will prevent you from accidentally
looping the tape around the steering linkage wire.
To Next Page