E-max Gaming Corporation, Inc.
46
System Power Issues:
Problem Possible Cause What to do or check
Electronics and Ball
consoles have no power
Hall power not available Check hall fuses or circuit
breakers
Outlet strip #2 power cord
not plugged into hall power
or outlet switch not on
Plug cord into 120 VAC,
grounded power source
UPS power switch not ON Depress power ON switch
UPS circuit breaker tripped Depress UPS circuit breaker
button on the back of the
UPS
Power available, but
Electronics console
equipment not powered
correctly
Dell AC cord unplugged
from UPS
Plug in Dell power cord to
UPS1 socket as shown in
the Appendix
Dell computer turned off Depress power ON button
on Dell computer
Operator Monitor AC cord
unplugged from UPS
Plug in Operator Monitor
AC cord to UPS2 socket as
shown in the Appendix
Operator Monitor turned off Depress Monitor ON switch
on the front panel of the
monitor
AC Outlet Strip 1 not
plugged into UPS
Plug strip into UPS as
shown in the Appendix.
Note that strip 1 must go
into UPS3 socket.
AC Outlet Strip 1 or 2
circuit breaker tripped
Reset outlet power switch to
ON position
Power available, but Ball
console equipment not
powered correctly
AC power cord to Ball
console not plugged into
Electronics console
Plug in power cord to
Outlet strip #2 socket as
shown in the Appendix
Blower motor unplugged or
blower motor circuit
breaker tripped
Inside the blower motor
compartment, check that the
AC power cord is plugged
into the outlet. Reset the
breaker switch on the outlet
Blower motor switch OFF Place the switch on the ball
tray to the ON position
UPS did not work properly
when AC power failed
UPS defective or battery
pack worn or defective
Call for service to replace
the UPS
UPS is beeping Low AC line voltage Specification in Appendix
To Next Page
Loading...