E-max BingoConsole - Bingo System Issues

E-max Gaming Corporation, Inc.
51
Bingo System Issues (as they relate to a Console problem):
Problem Possible Cause What to do or check
No video image on the hall
Ball Monitor or Message
Monitor
Video cable not plugged into
the console’s RF Modulator or
Data Router
Check video cabling as shown
in the Appendix
Video cable between the Dell
video card an the RF
Modulator or Data Router or
VCR not plugged in
Check video cabling as shown
in the Appendix
RF Modulator power cord
unplugged
Plug in power cord to the
Outlet strip as shown in the
Appendix
VCR turned OFF Turn on the VCR
VCR power cord unplugged Plug in power cord to the
Outlet strip as shown in the
Appendix
Defective RF modulator or
Data Router
Call for service.
Defective VCR Call for service.
Flashboards not operating Flashboard cable not plugged
into the Data Router
Check that cabling is plugged
into the correct RJ connector
on the Data Router as shown
in the Appendix
Data Router problem Check Data Router
troubleshooting procedures
shown above
Dell computer problem Check Dell troubleshooting
procedures shown above
Flashboard type not
compatible with new Console
Call for service.
Add on Electronic gaming unit
system does not work properly
with new Console
Not certified by Arrow as
compatible
Call for service.