E.T. Systems DC BLUE ADVANCED - A Quick Method of Learning a Transmitter Button Code

ET DC BLUE ADVANCED INSTALLER 2012.025.12.05.2014
22
www.et.co.za
A QUICK METHOD OF LEARNING A TRANSMITTER BUTTON CODE INTO THE RECEIVER MEMORY WITHOUT
ENTERING THE PROGRAMMING MENU.
Max users (BT) button trigger channel = 35 user codes
NB!! No remote codes can be learnt into the (LT) courtesy light channel this way.
Action
Response
Door must be closed Door closed
Press and hold the “Up”
button until buzzer beeps
and display shows “b”.
Buzzer beeps once and
display shows “b”
Press and hold required
remote button.
LED on remote
transmitter remains lit.
Press and release the
“SET” button.
“1” on display and 1
beep = user code
successfully registered.
“2” on display and 2
beeps = user code
already in the receiver
memory.
“3” on display and 3
beeps = Unsuccessful
because no code was
seen within 4 sec of the
“SET” button being
pressed.
Mandatory timeout.
“F” on display and
multiple rapid beeps =
Memory full
Release both the remote
button and “SET” button
Display reverts back
standby mode “II”
Memory full
Code already in
memory
Successful
Unsuccessful