Display - power button
• Hold down the power button (long press) to turn the scooter on and off.
• To turn on the lights the scooter must be turned on, and the power button must be short pressed once.
• To alternate between different modes, short press the power button twice (quickly).
Display Functions
Speedometer, power indicator, error code indicator, on/off -button for light, cruise control, gear change, and gear indicator.
Error codes - For questions regarding error codes, send your inquire to:
Norway: service@e-wheels.no
Europe: mail@ewheels.se
Error codes are easily recognized as they show an “E-“ followed by a number in the display. All error codes have different meanings and
are listed below:
E1 - Electrical components - Troubleshooting - Find out which electrical component has a defect (display, motherboard, etc)
E3 - Motor fault - To possibilities: 1. The motor could be incorrectly connected to the motherboard. 2. The motor must be replaced.
E4 - Brake handle - Brake sensor has a defect, the brake handle must be replaced.
E5 - Gas accelerator - Gas accelerator must be replaced.
E51 - The product needs service, send an inquire to: 1. Norway: service@e-wheels.no or 2. Europe: mail@ewheels.se
E52 - Incorrect start. Occurs if the scooter is being turned on while in speed or while braking. If this occurs otherwise, contact us.
H1 - Motor temperature high - Turn off and let it cool down. If the error code reoccurs, deliver the scooter for service.
H2 - Motherboard high temperature - Turn off and let it cool down. If the error code reoccurs, deliver the scooter for service.
H3 - Motherbard extreme high temperature - Turn off and let it cool down. If the error code reoccurs, deliver the scooter for service.
BH - Battery over-voltage - Drive two minutes uphill/straight regeneration/braking can then be used without error codes.
BL - Low battery voltage - Battery must be charged before the scooter can be used.
BP - Battery over-voltage - Drive two minutes uphill/straight regeneration/braking can then be used without error codes.
S1 - Short circuit in live conductors - Deliver for service.
SN - Wrong serial number - Deliver for service
IR - General error- Deliver for service
3.2 Display & Error Codes
EN
To Next Page
Loading...
Need help?
General
