3 OPERATIONAL INSTRUCTIONS
Always check the electric scooter before use. Check the brakes, make sure everything is tight, check the air
pressure and always use safety equipment.
3.3 Riding Instructions
3.3.1 Before riding
• Choose a suitable venue for riding, get familiar with your scooter.
• Assemble the electric scooter according to the instructions. We recommend you to always wear safety equipment.
• Make sure there is no slack in the steering column. If there is any, adjust it straight away and before use.
• Make sure you are familiar with the brake, brake length, and how the product behaves when braking before riding among
people/in traffic. Test first with low speeds and work your way up to a full emergency stop at high speed.
3.3.2 Riding
• Long press the power button to turn on the electric scooter.
• For safety purposes, all E2S models has a safe start design meaning the motor can start only when the speed of the vehicle is above
3km/h (can be adjusted in the KingSong app). This prevents the motor from starting if the accelerator is being pressed by mistake.
To start the ride put one foot on the standing board and the other on the ground. Then kick start the scooter like a normal kick
scooter. When the scooter is in motion and its speed is above 3km/h, gently use the gas accelerator to start the motor.
• It is extremely important to maintain a good and active weight balance on the standing board. Keep one foot in front and one foot
on the back of the board. When accelerating, distribute the weight more to the front foot. When braking, distribute the weight more
to the rear foot. This is to avoid wear on the handlebar. As a result of the Principle of Leverage, the force loaded at the bottom of
the steering column will be enormously when fully accelerating or braking if you pull and lean on the steering/handlebars. This is
avoided with active weight balance.
• Remember to use different gears when driving. Use the bell and the light when needed.
• Be aware of the cruise control mode. Cruise control is activated when the gas accelerator is being pressed with the same pressure
for 5 seconds.
• Be aware of the possibility of unpredictable, sudden obstacles on the road. Be rational regarding speed and adapt your riding to the
conditions and to the surface.
3.3.3 Braking
• When braking, use the brake handle. The mechanical brake as well as the electric motor brake will be activated when using
the brake handle. If the handle is too easy to depress, the brakes must be adjusted.
• The more pressure you use, the greater the braking force. Be aware that in the event of an emergency brake, the scooter
may slip further, and dangerous situations may arise.
• Avoid emergency braking unless necessary as this leads to worn tires and punctures.
EN
To Next Page
Loading...
Need help?
General
