MOTOR & MOTOR BRAKE
Page G-5
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Warnings and Dangers.
B
B
DO NOT drop the brake assembly. Dropping or hitting the
brake assembly will damage it.
Installation
1. Position the brake with the connector at the top as
shown above and install the three hex head bolts (32)
loosely.
2. Connect the negative (-) battery cable, tighten termi-
nal hardware to 95 - 105 in. lbs. (11 - 12 Nm).
3. Connect the wire harness to the motor brake and turn
the key switch to ’N’ (neutral) position. Move the Run/
Tow switch to the ’TOW’ position, this will provide
power to the brake to align the disc material. Slide the
brake disk to align the disc material.
4. Tighten the three hex head bolts evenly to the speci-
fied torque.
5. Move the Run/Tow switch to the ’RUN’ position and
turn the key to the ’OFF’ position.
Replace worn or damaged hardware as required.
ITEM TORQUE SPECIFICATION
32 53 - 71 in. lbs (6 - 8 Nm)
To Next Page
