Installation, Operation and Parts Manual
EE62C-35T-E / EE62C-42T-E
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be midway between adapters and centered over
the lift.
1. Park the vehicle between two posts.
2. Adjust the lifting arms until lifting trays are under the pick-up positions of the vehicle and make sure the gravity of vehicle
located over the center of four lifting arms.
3. Turn on the main power switch.
4. Push the UP button on the control box until lifting adapters have touched the pick-up positions of vehicle.
5. Keep on raising the vehicle making its wheels have a bit clearance off the ground and check again the stability.
6. Raise the vehicle to the height excepted, push the “Safety Lock” button to engage the mechanical safety locking unit. Check again
the stability and then perform maintenance or repair work underneath.
Lower the lift
When lowering the lift pay careful attention that all personnel and objects are kept clear.
1. Push the “DOWN” button on the control box. Meanwhile the lifting arms automatically go upwards about 5CM which releases the
mechanical safety locking unit. After that the lift starts descending.
2. When the lift is fully lowered, position the lift arms and adapters to provide an unobstructed exit before removing vehicle from lift
area.
3. Drive the vehicle away.
APS function
In the case the mechanical locking unit is released, push APS button and DOWN button for direct lowering.
To Next Page
Loading...