Eagle Tracker 3000 - Machine Operation; Safety Precautions During Machine Use; Before Operating the Machine; While Operating the Machine

Eagle Solutions, ©2008, Tracker Operator Manual Page #10
Eagle Solutions, ©2008, Tracker Operator Manual Page #11
This propane fueled machine is intended for
commercial use only.Do not use the machine
other than described din this Operator’s Manual.
All operators must read, understand and practice
thesafetyprecautionsinthismanual.Onlytrained
and authorized operators should operate propane
poweredoormachines.Checkfuelcylindersfor
overllbeforetakingthemintothebuildingoryour
vehicle.
Before Operating the Machine
• Checkoillevel.
• Checkcarburetorairlter.
• Checkpadandpadholder.
• Adjusthandleheight.
• Installfuelcylinderinawellventilatedarea.
While Operating the Machine
• Eagle Solutions recommends wearing hearing
protection while operating any internal
combustionengineinanenclosedarea.
• If you smell the odor of propane, stop the
engine,removethecylinderandtakeitoutside
forinspection.
• Be aware of odors other than propane. Toxic
emissionsareproducedbyinternalcombustion
engines.Properlymaintainedenginesproduce
asmallamountofthesegasesincludingcarbon
monoxide.Althoughcarbonmonoxidehasno
odor,thehydrocarbonsdoandanelevationof
odormayindicateincreasedCOaswell.
• Donotallowthemachinetorununattended.
• ExhaustpartsareextremelyHOT.Becareful
not to allow them to come into contact with
anythingoranyone.
• Donotattempttochangebrushesor
padswhile
theengineisrunning.
Machine Storage
• Stoptheenginebyclosingtheservicevalveon
thefuelcylinder.
• Removethekeyfromtheswitch,ifapplicable.
• Removethefuelcylinderfromthemachineand
storeitoutsideinasecure,approvedcabinet.
• Cleanandinspectairanddustlters.
Servicing the Machine
Planned maintenance is the responsibility of the
operator.Itincludes:
• Checkingoillevel.
• Checkingandcleaningairanddustlters.
• Keepingmachinecleanandlubricated.
• Reporting any damaged or worn parts to
supervisor
• SeeMaintenancesectionforservicingintervals
andinstructions.
• Servicingoradjustingthepropanefuelsystem
should only be done by a trained service
technician.
• Never attempt to adjust the fuel system of a
propaneengine!If equippedwithanemission
monitoringorcontrollingsystemneverattempt
todisconnectitorcircumventit!
Additional Safety Concerns
and Precautions
• Operatormusthavecompletedtrainingbefore
usingmachine.*
• Sweepoorandcheckforitemsprotrudingout
oftheoorsurfacebeforestarting.
• Nevertiltthemachinebackwhileitisrunning.
• Do not start engine with the transport wheel
attached.
• Exercise extreme caution when installing or
changingbrushesorpads.Themachineisvery
heavy!
• Checkforlooseboltsandnutsdaily.
• Clean carburetor air lters after four hours
running and clean or replace daily before
operation.
• Cleanentire machine aftereach useincluding
underthegeardriveassembly.
• Because of the length of timethese machines
may operatecontinuously it is very important
tobeassuredofproperventilation.
• Neverattempttobypassordisconnectthekill
switchoranyothersafetydevices.
*To arrange for operation and safety training
contactEagleSolutionsbyphoneat770.773.3875,
email customerservice@eagleoorsolutions.com
or mail request to P.O. Box 350,Adairsville, GA
30103.
Machine Operation
Safety Precautions During Machine Use
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com