EarthPulse v.5Basic - C) Testing Electromagnet Output

C) Testing Magnetic Output:
1) With blue-diode blinking; Lay the fatter rounded side of the ring
across the center of the solid electromagnet core (as shown in photo
below);
2) Raise ring 1/4-1/2 inch (1-2 cm) above core to feel pulsing signal;
3) Move to 3/4 inch or 2-3 cm above core and it is very weak if not
relatively unnoticeable;
4) Use UP/DOWN arrow keys in active mode while holding ring at
1/4 inch (1MM) position to feel amplitude change.
4a)
v.5Pro; Repeat steps above for both magnets.
At 100% amplitude, coils reach 117˚F (47˚C) at 10-hours runtime
under feather pillow in Alert-Mode (maximum pulse rate). If this com-
pletely safe level of heat makes you uneasy, operate at lower am-
plitude when magnet is trapped in bedding. While it may feel hot to
touch on the palm side of hand, it should feel a bit more than warm
to the back of hand. At boot amplitude (70%) there is little to no heat
depending upon type of bedding and ambient temperature. We be-
lieve that the coil at 117ºF is perfect heat for long duration local use,
and works synergisticvally with our PEMF.
Testing Magnet Output
20