EarthPulse v.5Basic - EarthPulse Quick Start Guide; Getting Started and Device Setup

Chapter 2: QUICKSTART
A) Getting Started Sleep on Command v.5Basic/ProBasic
Contents:
• Sleep on Command™ v.5Basic or v.5ProBasic controller
• Power supply 100 - 240 volt AC to 12 volt DC
• Modular electromagnet (Basic) or two electromagnets (ProBasic)
• International pin adapter for your shipping location
• Padded carrying-case
1) Please complete at least one Resting-Breath-Hold (RBH) test
according to instructions BEFORE your initial session.
2) Plug the POWER-SUPPLY into wall outlet (100 - 240 volts AC / 50
or 60 Hz). Use international pin adapter if required.
3) Plug power-supply cable into the large jack on back of control unit.
17