EasyManua.ls Logo

EarthPulse v.5Basic - Manual Mode Programming; Manual Frequency Range Operation

EarthPulse v.5Basic
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
Chapter 3: MANUAL MODE PROGRAM
A) Manual-Mode Frequency Range 1/2 Hz - 14.1 Hz:
With MANUAL FREQUENCY MODE you are free to experiment
sleeping / recovering / meditating with any one particular frequency.
It may be one of the Schumann peaks at 1.5 Hz (1.2 Hz?) or 2.5 Hz
(2.4 Hz?) or 7.8 Hz; or 9.6 Hz or 10 Hz (or any choice in between
.5 and 14.1 Hz). At end of timer device controller shifts to wake-up
mode 14.1 Hz.
v5Basic uses MANUAL-FREQUENCY-MODE for sleep by setting
any frequency from 1/10 Hz to 10 Hz with timer setting up to 12
hours. For ALERT use 12 - 14.1 Hz. 12 Hz also has some strange
harmonic resonations, so be sure to try it, rather than just go for the
fastest settng out of the gate.
The 1 hour 14.1 Hz buffer effectively becomes the wake up part of
program. Author nds 2.4 Hz, 4.8 Hz and 9.6 Hz particularly good
at recovering during the night and rarely ends up sleeping a full 8
hours without waking on his own long before the timer runs to wake
up phase. See Why 9.6 Hz and it’s strange harmonic relationship to
healing tones, sacred geometry and terrestrial measurements.

Table of Contents