If RED diode on POWER-SUPPLY is not lit,
• check that wall outlet or power strip is turned on
If no power on EarthPulse™ CONTROLLER;
• be sure red LED on power supply is lit
• check connection between POWER-SUPPLY and CON-
TROLLER by unplugging and replugging then On/Off button to at-
tempt power on again
• when plugging in power supply you should see LCD screen
light momentarily if power supply is delivering sufcient voltage.
If controller screen characters become jumbled, are missing or very
light, power off 5 sec. and power on again. If this problem becomes
persistent please accept our apologies and email for service.
38
If any of suggestions above fail to resolve issue please email tech-
support for repair or replacement instructions.
Sleep-well, live long and prosper.
©SleepTech 2002 - 2016
Get Charged!
BACK TO TABLE OF CONTENTS:
To Previous Page
Loading...