18
General maintenance
If the product is installed in public spaces and is
accessible to everyone, observe local and national
requirements (e.g. BS 7671) in addition to the procedures
below.
— Ensure that the charger does not have any signs of
mechanical damage.
— Visually inspect the Type 2 socket for wear and tear
at regular intervals according to local regulations. If
the pins are discoloured or damaged, please contact
your authorised electrician.
Cleaning
The product does not require cleaning to operate
properly. Nevertheless, if the product needs to be
cleaned for cosmetic reasons, this is possible.
— Use a damp cloth and an all-purpose household
cleaner. Avoid using strong chemicals that contain oil
or alcohol, as this will discolour the plastic.
— Do not use running water or high pressure water jets.
Insulation testing (authorised electrician only)
Insulation testing should be performed before
a Chargeberry is installed in the backplate.
Testing the circuit insulation with the
Chargeberry installed in the backplate may
damage the electronics or impact the reading
negatively.
Maintenance Practical details
Warranty
The device is free from material defects and is in
accordance with laws and regulations for consumer
protection in the country where the product is
purchased. All correctly installed Easee hardware is
covered by our 3 years* limited warranty. If your charger
needs to be repaired within this warranty period, please
contact your Easee supplier. Further information can be
found at easee.support.
*Some countries may have extended warranty.
Safety
The product shall be installed according to local
regulations for low voltage electrical installations.
The product is designed and tested according to the
EN 61851 standards for electric vehicle conductive
charging system. It includes a built-in RCD able to safely
break the circuit in the event of a 30 mA AC or 6 mA
DC fault in accordance with IEC 61008 and IEC 62955.
The charger also has an integrated broken PEN lead
protection according to BS 7671:2018/A1:2020.
Standards
Hereby, Easee AS declares that this product, Easee One,
is in compliance with the Electrical Equipment Safety
Regulations 2016, Radio Equipment Regulations 2017,
EMC Regulations 2016, RoHS Regulations 2012 and the
UK Smart Charging Regulations.
The full text of the UK Declaration of Conformity
and the UK Smart Charging Regulations Statement
of Compliance and Technical File are available at the
following internet address: easee.support.
To Next Page
Loading...
