7
Read the entire manual carefully before installing
and operating the product. Observe the following
instructions:
Safety instructions for the installation
— This product shall only be installed, repaired or
serviced by an authorised electrician. All applicable
local, regional and national regulations for electrical
installations must be respected.
— Danger to life due to high electrical voltage. Never
make any changes to components, software or
connecting cables.
— The installation must not be carried out in the vicinity
of explosive atmospheres or in areas where there is a
risk of flowing water.
— The product must be installed on a permanent
location. The connections of the Chargeberry and
backplate are designed for a limited number of
plugging cycles.
— The product must be installed on a wall or structure
with sufficient load bearing capacity.
— The charger must always be installed on a surface
that covers the entire back side area of the product.
— The terminals in the backplate are energised when
the power circuit is closed and must never be in direct
contact or in contact with anything other than the
plug-in electronics (Chargeberry).
— The PIN code is located on the front of the
Chargeberry and is required for installation. After
installation, paste the PIN code on the back of the
manual or in a safe place, e.g. inside of the fuse
cabinet door.
Safety instructions
Safety instructions for operation
— Danger to life due to high electrical voltage. Never
make any changes to components, software or
connecting cables.
— Never use or touch the product if it is damaged or
does not function properly.
— Always have the prescribed maintenance, installation
and any repair work carried out by an authorised
electrician and in accordance with local requirements.
— If a fire occurs, use CO2 for extinguishing. To
extinguish it with water or foam, the system must be
first de-energized (electrically disconnected).
— Never clean the Charging Robot with high pressure or
running water.
— Do not immerse the product in water or other liquids.
— If the light strip on the product lights up red, there is a
fault. For more information, see page 17.
— Make sure that children do not play with the product.
— Never touch the contacts of the Type 2 socket and
never insert foreign objects into the product.
— Never use the charging cable if it is damaged or if the
connections are wet or dirty.
— Do not use extension cords or adapters in
combination with the product.
— The charging cable must only be removed from the
Charging Robot by pulling the plug handle, not by
pulling the cable.
— Make sure the charging cable does not cause a
tripping hazard or risk being run over by a car.
— Avoid direct sunlight for optimal operation in all
weather conditions.
— Do not use the product near strong electromagnetic
fields or in the direct vicinity of radio transmitters.
To Next Page
Loading...
