What to do if my East EA903P UPS shows fault code 50-54 indicating an overload?
If the East UPS displays a fault icon, sounds an alarm, and shows fault code 50-54, it indicates an overload. Check the load level, disconnect non-critical equipment, and recalculate the total capacity to reduce the load on the UPS. Also, inspect the connected equipment for any faults.
Why is the backup time so short on my East EA903P UPS?
If the backup time of your East UPS has become short, there are several possible causes. First, the battery may be undercharged; keep the UPS battery recharging for more than 3 hours. Second, the UPS may be overloaded; check the load level and disconnect any non-critical equipment. Finally, the battery may be old and its capacity diminished; consider replacing it.
What to do if my East EA903P UPS displays fault code 45-49 indicating a short circuit?
If your East UPS displays a fault icon, sounds an alarm, and the fault code is 45-49, it means there is an output short-circuit. To resolve this, turn off the UPS, disconnect all loads, and ensure there are no faults or internal short circuits in the loads. Then, restart the UPS.
What to do if my East EA903P displays fault code 40-44 for over temperature?
If your East UPS displays a fault icon, sounds an alarm, and shows fault code 40-44, it indicates an over-temperature issue inside the unit. Ensure the UPS is not overloaded, the fan vent is not obstructed, and the room temperature is not too high. Allow the UPS to cool down for 10 minutes before restarting it.
Why won't my East EA903P turn on when I press the power button?
If your East UPS fails to start when you press the 'On' key, there could be a few reasons. Ensure you press the power key for more than 2 seconds. Check that the input connection is properly connected or if the internal battery is disconnected. If the battery voltage is too low, disconnect the input and start the UPS with no-load.
What does it mean when my East EA903P displays fault code 65-69?
If your East UPS displays a fault icon, sounds an alarm, and the fault code is 65-69, it indicates an input fuse fault. Check if the input fuse is burnt. If it is, replace it with a new fuse and restart the UPS.
Why doesn’t my East EA903P UPS have power even when plugged in?
If your East UPS has no power going through it even when the mains power is on, it might be due to a disconnected input breaker. Try resetting the circuit breaker manually.
What does it mean when the fan icon is flickering on my East UPS?
If the fault icon is displayed, the buzzer sounds continuously, and the fan icon flickers on the LCD of your East UPS, it indicates a fan fault. Check if the fans are properly connected and fixed, and ensure they are not broken.
What does fault code 00-14 mean on my East UPS?
If the East UPS shows a fault icon, sounds an audible alarm, and displays the fault code 00-14, it indicates a bus bar voltage fault. Test the bus bar voltage.
What does fault code 15-24 mean on my East EA903P?
If your East UPS unit is showing a fault icon, the buzzer is alarming continuously, and the fault code displayed is 15-24, this indicates a soft start fault. You should check the soft start circuit, especially the soft start resistance.
General safety precautions for operating the UPS unit.
Safety guidelines related to UPS battery installation and handling.
Guidelines for selecting a proper installation environment and positioning the UPS unit.
Instructions for connecting the UPS output to various loads and power outlets.
Steps for connecting external battery banks to the UPS for extended backup runtime.
To Next Page
General
