EW-5010A OPERATION MANUAL
Machine removal and installation
1. After taking out the machine, confirm whether there is any
transportation damage or other mechanical parts falling off in the
machine box.
2. After the machine is taken out, open the right box door and remove
the internal transport fixed part of the cable tie (as shown below left),
and take out the jig accessory box in the rubber waste box.
3. After taking out the jig accessory box, release the rubber waste box
until the magnet catches it.
4. Before ventilating, the rotating and swinging mechanism keeps the
vertical position (the position on the left below is vertical).
5. The air source and power interface are in front of and behind the
machine.
To Next Page
Loading...