Why does the pilot arc continue while cutting with my Eastwood 58221?
If the pilot arc continues while cutting with your Eastwood Welding System, a faulty reed switch may be the cause; replace the reed switch if it does not close. Another possibility is a faulty arc gap on the bottom board; clean and adjust the arc gap as necessary. Additionally, the bottom board itself could be faulty and require replacement.
Why does my Eastwood 58221 Welding System turn on but the power light does not illuminate?
If your Eastwood Welding System turns on but the power light doesn't illuminate, there could be an open or loose connection in the power light circuit; repair any loose connections. The top board might be faulty and need replacement. Alternatively, the power indicator light itself could be faulty and require replacement.
Why is there no delay in air flow shut off when the trigger is released on my Eastwood 58221?
If there is no delay in air flow shut off when the trigger is released on your Eastwood Welding System, the bottom board may be faulty and needs replacement.
General| Input Voltage | 120V |
|---|---|
| Type | MIG |
| Output Current Range | 30-140 Amps |
| Duty Cycle | 20% at 90 Amps |
| Wire Size Compatibility | 0.023-0.035 inches |
| Welding Processes | MIG (GMAW), Flux-Cored (FCAW) |
To Next Page