What to do if Eastwood Welding System shows Err-01 or Err-02 and will not function?
If the Eastwood Welding System's digital display shows Err-01 or Err-02 and will not function, it's likely the duty cycle has been exceeded. Allow the welder to cool down for a minimum of 15 minutes before attempting to use it again.
General| Brand | Eastwood |
|---|---|
| Model | MP200i |
| Category | Welding System |
| Language | English |
Attaching the front caster assembly to the welder's underside.
Attaching the rear wheel and tray assembly to the welder's cabinet.
Mounting gas cylinder brackets to the rear of the welder cabinet.
Description of front panel controls, displays, and buttons.
Identification of rear panel connections and switches.
Connecting the MIG gun to the welder's power/gas/wire feed socket.
Connecting the ground clamp for solid wire MIG welding.
Adjusting the drive roller for different wire sizes.
Procedure for installing a 4-inch wire spool.
Procedure for installing an 8-inch wire spool with adapter.
Overview of MIG mode settings and interface adjustments.
Accessing advanced MIG welding settings via the user menu.
Techniques for welding thin sheet metal, including stitch welding.
Techniques for welding thicker metal using continuous or patterned beads.
Steps for installing the optional spool gun onto the welder.
Grounding procedures for spool gun welding.
Connecting or swapping gas lines for spool gun welding.
Connecting the TIG torch to the welder's power/gas connector.
Connecting the ground clamp for TIG welding.
Connecting the foot pedal for TIG welding control.
Assembling the TIG torch components.
Operating and adjusting DC TIG welding mode settings.
Accessing advanced DC TIG welding settings.
Understanding default AC TIG display and adjustments.
Accessing advanced AC TIG welding parameters.
Understanding and setting polarity for stick welding.
Setting up for DC Stick welding (DCEP).
Setting up for DC Stick welding (DCEN).
Choosing the appropriate electrode based on material and polarity.
Understanding DC Stick default display and settings.
Accessing VRD and factory defaults in DC Stick mode.
Troubleshooting MIG wire feeding issues.
Troubleshooting MIG wire burn-back.
Troubleshooting failure to produce an arc.
Addressing intermittent welding arc issues.
Troubleshooting MIG gun shielding gas flow issues.
Diagnosing TIG arc initiation failure.
Troubleshooting TIG arc instability and heat concentration.
Correcting porosity in TIG weld beads.
Addressing weld contamination in TIG welding.
Troubleshooting tungsten melting during TIG welding.
Solutions for electrode sticking in stick welding.
Troubleshooting porosity in stick weld beads.
Correcting insufficient penetration in stick welding.
Addressing excessive spatter in stick welding.
Troubleshooting display errors and welder functionality.
To Next Page
