EasyIO FW-08 - Introduction

EasyIO FW Series– Installation Guide v2.0
6
Introduction
This document provides the installation guide/mounting guide for the EasyIO FW Series controller.
Do not mount the EasyIO FW Series:
- In an area where excessive moisture, corrosive fumes or explosion vapors are present.
- Where excessive vibration or shock is likely occur.
- Location where excessive electrical noise such as large magnetic interference or variable speed
drive modules
FW Series range of products comes in few options.
Options are referring to IO (Input/Output) configurations.
FW
Model
UI
AO
DO
Pressure
Sensor
Ethernet
EIA-485
Protocol Supported
FW-28
16
4 (Voltage only)
8
0
2
1
Sedona
BACnet MSTP Client
BACnet IP server
Modbus RTU Master
FW-14
8
4 (Voltage only)
2
0
2
1
Sedona
BACnet MSTP Client
BACnet IP server
Modbus RTU Master
FW-08
4
4 (Voltage only)
0
0
2
1
Sedona
BACnet MSTP Client
BACnet IP server
Modbus RTU Master
FW-08V
4
4 (Voltage only)
0
1
2
1
Sedona
BACnet MSTP Client
BACnet IP server
Modbus RTU Master