23
6. Touch the drop on the bottle
to cap the tip of the test
strip.
7. The meter starts to count
down from 5 seconds and
then will display result.
8. Do not remove the test strip yet.
Check if the reading falls within the
range printed on the test strip bottle.
9. Press power button to repeat the test
result. Or you can also press C
button or M button to set the volume
before repeating the result.
10. Remove the test strip and throw
it away after you have compared
the reading to the range printed
on the test strip bottle.
11. Please check if the result on the
display is the same as audible
result.
Note: Be aware that there are normal, high and low ranges listed on your test strip bottle. The
normal, high and low refer to the three different control solutions that are available. Please
be sure that you are looking at the correct range.
To Next Page
Loading...
