30
5. Gently squeeze and/or
massage your fingertip
until a round drop of blood
on your fingertip.
6. Touch the blood drop at the tip of the
transparent window of the test strip.
Do not put blood on top of the strip.
Be sure to get enough blood on the
strip’s reaction zone. Otherwise, an
inaccurate reading may result.
7. The meter starts to count down from
5 seconds and speaks the result.
8. Press power button to repeat the
test result. Or you can also press C
button or M button to set the volume
before repeating the result.
9. Remove the test strip and the meter
turns off automatically.
10. Wash hands thoroughly with soap
and water after handling the meter,
lancing device and test strips.
Note: 1. Please make sure to apply blood when the blood drop appears on the display.
2. Please check if the result on the display is the same as audible result.
To Next Page
Loading...
