EasySplicer mk2 - Place the cleaved and ready fibers in the splicer

Close the lid of the cleaver and push the sliding part away from you.
The fiber will be cut off (cleaved) and get a very straight 90´ angle
Lift the fiber holder in order to prevent the fiber from getting dirty.
Place the cleaved and ready fibers in the splicer
Open the main lid (on top) of the splicer and lift up the little bracket on top of the v-groove.
Place the fiber holders in their wagons.
- Keep the fiber holder at an angle and move it pass its intended resting place
Lay the holder down and let it slide back into position (where the magnets will lock it).
Don´t try to push them in place from the outer position as it will be very hard to make the
fiber fall in place into the v-groove. See picture below and our videos at:
https://www.dropbox.com/sh/t1bwwrk0i9str6a/AAAKnje_Mvc-_SeXVUH1v0Jva?dl=0
15