Need help?Do you have a question about the EasySplicer mk2 and is the answer not in the manual?
Display| display size | 2.8 inches |
|---|---|
| display type | Color TFT |
| magnification | 140x |
Power| battery voltage | 7.4 V |
|---|---|
| battery capacity | 3400 mAh |
| power supply | 100-240V AC / 6V DC / 1.5A |
Operating Environment| operating temperature | 0˚C to 45˚C |
|---|---|
| operating humidity | max 95% RH, non-condensing |
| storage temperature | -20˚C to 45˚C |
Memory and Communication| internal memory | 1 MB |
|---|---|
| external memory | SD-card up to 32 GB, FAT32 file system |
| communication ports | USB, mini USB-plug |
Weight and Dimensions| weight | 800 g |
|---|---|
| dimensions | 230x98x53 mm |
| sleeve dimensions | Max 60mm length, 2-5mm diameter |
Provides a quick guide to powering on the EasySplicer mk2 and initial setup for operation.
Explains the importance and procedure for calibrating the splicer to its environment.
Details how to select the correct fiber type in the splicer menu for accurate splicing.
Guides users on placing fibers into the correct holders for the splicing process.
Explains how to perform environmental compensation calibration for accurate splices.
Procedure to select the correct fiber type (Single mode, Multi mode, OM1) for splicing.
Automatic guide for adjusting the splicer electrodes for optimal performance.
Resets the splice counter after electrodes have been replaced.
Action: Calibration failed 3 times. Resolve: Clean electrodes electronically and mechanically.
To Next Page