Why is my Eaton 5S 700 UPS operating on battery when AC power is available?
If the Eaton UPS operates on battery power even when AC power is available, it might be because the circuit breaker located at the rear of the UPS has been tripped due to an overload. To resolve this, disconnect some equipment and reset the circuit breaker by pressing the corresponding button.
General| Power Rating | 700 VA |
|---|---|
| Output Power | 420 W |
| Input Voltage | 230 V |
| Output Voltage | 230 V |
| Output Voltage Regulation | ± 10% |
| Frequency | 50/60 Hz |
| Communication Ports | USB |
| Surge Protection | Yes |
| Transfer Time | 2 - 6 ms |
| Form Factor | Tower |
| Weight | 5.5 kg |
| Operating Temperature | 0 °C to 40 °C |
| Operating Humidity | 0% to 95% non-condensing |
| Topology | Line Interactive |
| Outlets | 4 x IEC C13 |
| Battery Type | Sealed Lead Acid |
| Typical Backup Time at 50% Load | 9 min |
| Typical Backup Time at 70% Load | 5 min |
| Typical Backup Time | Varies by load |
| Safety Certifications | CE |
| Battery Runtime | Varies by load |
To Next Page
