5
Model 70523
Parts List
Item Part No. Qty. Description
1 ♦ 1 Drive Shaft (Identification drawing on page #6)
2 ♦ 1 Backplate Assembly (Identification drawing on page #7)
3 ♦ 1 Housing Assembly (Identification drawing on page #10)
3-1 77010-9 1 Bearing
4 ♦ 1 Compensator Assembly (Identification drawing on page #8 & 9)
5 ♦ 1 Rotating Kit Assembly (Parts list on page #10)
6 70523-605 1 Camplate
7 70523-423 1 Control Piston
8 16026-608 1 Roll Pin
9 16028-604 2 Dowel Pin
10 70523-618 2 Cover
11 16048-329 1 Washer
+ 12 16077-34 3 Retaining Ring
+ 13 16078-22 2 Retaining Ring
14 16147-412 4 Cap Screw
15 16241-2233 1 Thrust Bearing
16 16241-C2233 2 Thrust Bearing Race
17 17091-12 1 Spring
18 70420-35 1 Pivot Button
19 70500-100 2 Inner Race
20 70500-101 2 Thrust Bearing
21 70500-600 2 Trunnion Cover
+ 22 70500-604 1 Gasket
23 70523-400 1 Spring Collar
+ 24 70523-610 1 Gasket
+ 25 16232-22 1 Shaft Seal
25 16233-22 1 Shaft Seal, Drive (fluorocarbon rubber)
+ 26 16003-408-90 1 O-ring, 2.38 mm Dia. x 9.525 mm ID. [.0937 in. Dia. x .375 in. ID.]
+ 27 16004-3 2 O-ring, 3.175 mm Dia. x 47.625 mm ID. [.125 in. Dia. x 1.875 in. ID.]
27 16004-403 2 O-ring, 3.175 mm Dia. x 47.625 mm ID. [.125 in. Dia. x 1.875 in. ID.] (fluorocarbon)
28 16246-612 1 Key, Used on 31.75 [1.25] diameter shaft
29 16032-734 4 Cap Screw
30 16032-720 2 Cap Screw
32 70400-646 1 Mount Adapter, SAE "A" to "B" flange
33 16147-610 2 Cap Screw
34 16007-14 1 O-ring, (In K2 & K3 kit)
35 70411-617 1 Coupler, for 9 tooth spline
35 70411-604 1 Coupler, for 13 tooth spline
Mounting Kits (Drawings and parts list on Page #11)
K2 70442-929 1 Gear Pump Mounting Kit
K3 70142-915 1 Cover Plate Kit, (for "A" SAE flange)
K6 990596-000 1 Cover Plate Kit, (for "B" SAE flange)
Seal Repair Kit
• 70523-900 1 Seal Repair Kit
Legend ♦ Refer to specific item parts list.
+ Included in seal repair kits listed.
To Next Page
