What to do if my Eaton UPS display does not light up?
If the display of your Eaton UPS doesn't light up, here's what you can check: * Ensure the input switch on the back of the UPS is closed. * Verify the power cable is correctly connected. * Confirm that power is reaching the UPS, and there is no blackout. * Check for and reset any upstream thermal protection trips. Be cautious of potential output overloads to the UPS.
Why does my Eaton 9E20K-TH beep and show A004 or F004?
If your Eaton UPS buzzer sounds continuously and the display shows code A004 or F004, the temperature inside the UPS is too high. Make sure the environment where the UPS is located does not exceed 40°C.
What does it mean when Eaton 9E20K-TH UPS beeps and shows code F805?
If the buzzer of your Eaton UPS is sounding continuously and the display shows code F805, there is a fault on one or more of the loads powered by the UPS. To resolve this, disconnect all the utilities, switch the UPS off and back on again. Then, reconnect the utilities one at a time to identify the faulty one.
What to do if Eaton UPS beeps and shows A80E, A810, or F808?
If your Eaton UPS buzzer sounds continuously and the display shows code A80E, A810, or F808, the load applied to the UPS is too high. Reduce the load to within 100% of the threshold (or the user threshold in the case of code A80E). If the display shows a fault, remove the load and switch the UPS off and back on again.
How to fix Eaton 9E20K-TH display not lighting up?
If the display of your Eaton UPS doesn't light up, check the following: * Ensure the input switch on the back of the UPS is closed. * Verify the power cable is correctly connected. * Confirm that power is reaching the UPS (no blackout). * Reset the thermal protection, but first, ensure there's no output overload to the UPS.
What to do if Eaton UPS beeps and shows F704, F70D,F70C,F302, F303,F305,F300,F301,F304, or F002?
If your Eaton UPS buzzer sounds continuously and the display shows code F704, F70D, F70C, F302, F303, F305, F300, F301, F304, or F002, the UPS is malfunctioning. If possible, disconnect the power to the load, switch the UPS off and back on again. If the problem persists, contact the support center.
General| Power Rating | 20 kVA / 18 kW |
|---|---|
| Output Power Factor | 0.9 |
| Topology | Double Conversion Online |
| Form Factor | Tower |
| Operating Temperature | 0 to 40 °C |
| Humidity | 0-95% non-condensing |
| Warranty | 2 years |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Battery Type | Lead-acid |
| Storage Temperature | -15 to 45 °C |
| Communication Ports | RS-232, USB |
To Next Page
