29
II. Bridge the ‘AC segment terminal N/N’ with ‘busbar #1’, then connect the AC
cable (N) to it
III. Bridge the ‘AC segment terminals L1/L2/L3’ with ‘busbar #3’, then connect the
AC cable (L) to it
3. Connection to the UPS:
I. Remove all the busbars of the UPS
II. Connect the UPS to the MBP with the ‘Cable to UPS1’ included in the MBP’s
accessory
3.1.7 Mode 1-3(single source)
To Next Page
Loading...
