31
3.1.8 Mode 1-3(Dual source)
1. Input:
I. Connect the main-ground cable (PE) to the chassis
II. Bridge the ‘AC input terminal N/N’ with ‘busbar #1’
III. Connect the AC main source cable (N) and bypass source cable (N) with lugs
on top of each other to the aforementioned N/N terminal busbar #1
IV. Bridge the ‘AC input terminals mL1/mL2/mL3 with ‘busbar #5’, then connect the
main source cable (L) to it
2. Output:
I. Connect the ground cable (PE) to the chassis
II. Bridge the ‘AC segment terminal N/N’ with ‘busbar #1’, then connect the AC
cable (N) to it
III. Connect the ‘AC segment terminals L1/L2/L3’ to the AC cables (L1/L2/L3)
To Next Page
Loading...
