Eaton 9SX 15K Series - Page 46

46
3.3.7 Mode 1-3(single source) ：
1. Input:
I. Connect the main-ground cable (PE) to the chassis
II. Bridge the ‘AC input terminal N/N/N’ with ‘busbar #9’, then connect the AC cable
(N) to it
III. Bridge the ‘AC input terminal mL1/bL1/mL2/mL3’ with ‘busbar #14’, then
connect the AC cable (L) to it
2. Output:
I. Connect the ground cable (PE) to the chassis
II. Bridge the ‘AC segment terminal N/N/N’ with ‘busbar #3’, then connect the AC
cable (N) to it