Eaton Airflex VC 5000 - Backing Plate, Springs, and Side Plates Wear; Removal Procedures

50
.
51
.
5.1.1
5.2
5.2.1
53
.
5.3.1
SPARE PARTS STORAGE
6.0 ORDERING INFORMATION/
TECHNICAL ASSISTANCE
Element Assemblies
Element assemblies must always be stored
flat. Storage in the standing position may
cause the rims to go out-of-round.
Drums
Drums must be stored open end down.
Similar to element assemblies, storage of a
drum in the standing position will adversely
affect roundness.
Air Actuating Tubes
Air actuating tubes are shipped from the Airflex
plant folded to conserve shipping space. Upon
receipt, remove the tube from its crate and
allow it to assume its natural shape. Store in a
cool, dry area, away from electrical equipment
and ultraviolet light.
61
.
Equipment Reference
6.1.1
In any correspondence regarding Air-flex equip-
ment, refer to the information on the product
nameplate. If not available, note the drum
diameter, air connection configuration, mount-
ing arrangement or any other special features
and call or write:
THE PARTS LISTS ON THE FOLLOWING PAGES APPLY TO
STANDARD ELEMENT ASSEMBLIES ONLY. ELEMENTS USED
ON SLIP OR HIGH-TORQUE APPLICATIONS WILL HAVE DIFFERENT
COMPONENT PARTS. CONSULT THE AIRFLEX FACTORY OR AN
AUTHORIZED AIRFLEX DISTRIBUTOR PRIOR TO ORDERING
REPLACEMENT PARTS FOR ANY ELEMENT NOT APPEARING ON
THE FOLLOWING LISTS.
16
0 Copyright Eaton Corp., 1989. All rights reserved.
VC 5000
Revised: July, 1995 (PDF format)