FRICTION SHOE ASSEMBLY
WITHDRAWN
.
Arr
Pressure
Source
2.0 INSTALLATION
2.1
Mounting Arrangements
ing
- Side Plate
F
Rim
n
! Warning:
Only qualified personnel should
install, adjust or repair these units.
Faulty workmanship will result in
exposure to hazardous conditions
or personal injury.
n
! Caution:
Do not inflate the element without
having a drum in place. Inflation of
the element without a drum in place
will result in permanent damage to
the element components.
Y
vc
5000
Tube
Drum
Surface
ICTION MATERIAL CONTACT
Actuating
Z
Air Pressure
Tube
(Inflated)
Release Spring
(Compressed)
r,
Fig.
2
WITH DRUM
Contact
/
With Drum
2.1.1
Figure
3
illustrates the gap-mounting arrange-
.
ment. In this arrangement, the element is at-
tached to a spider which is typically mounted
onthe
driving shaft. The drum is attached to a
drum hub which is typically mounted on the
driven shaft. The gap between the two shafts
allows the element and drum to be removed
without disturbing either shaft.
---
Note: The text in the Installation, Alignment
and
Removal’Sections
refer to this type of
mounting arrangement.
3
0
Copyright Eaton Corp., 1989. All rights reserved.
.
_
Revised: July, 1995 (PDF format)
To Next Page
Loading...
