Eaton Airflex VC 5000 - Page 5

SINGLE NARROW & SINGLE WIDE
Device
I J
Fig. 4
DUAL NARROW
Outboard
Element
n-
5\
Brake Reaction
DUAL WIDE
Outboard Bracket
Fig.
5
/
Element
2.1.4
Figure 6 illustrates a typical marine main
propulsion application. In this arrangement,
the element is attached to a pinion adapter
plate and the drum and drum hub are attached
to a quill shaft. A manifold is attached to the
outboard end of the element for bearing
support of the quill shaft.
*
Pinion
1111 I-
Adapter
t
J
I
Manifold
Fig. 3
2.1.2
Figure 4 illustrates the gap-mounting arrange-
ment with an axial locking device. The axial
locking device restricts the relative axial
motion between the driving and driven shafts.
This arrangement is typically used where a
synchronous motor armature with plain bear-
ings must be held on magnetic center.
\Quill
Shaft
2.1.3 Figure 5 illustrates a typical VC brake applicao9
tion. The drum and drum hub are attached to
the shaft which is to be stopped. The element
is attached to a rigid reaction bracket.
Fig. 6
4
0 Copyright Eaton Corp., 1989. All rights reserved.
VC 5000
Revised: July, 1995 (PDF format)